Notes On The Stop/Cut Position Of Different Media - SATO FX3-LX Operator's Manual

Hide thumbs Also See for FX3-LX:

Table of Contents

Notes on the Stop/Cut Position of Different Media

Stop Position of the Label in Dispenser Mode

The regular position is to let the label stay about 2 ± 1 mm (0.08" ± 0.04") on the liner.

(1) Feed direction

(2) Dispenser bar

(3) Stop position

Cut Position When Using the Label in Cutter/Partial Cutter Mode

The regular cut position is between labels (only cut on the liner).

When you cut the label, the glue adheres to the blade of the cutter and the blade will decrease the

performance of the cutter. Adjust the cut position so as not to cut the label.

(1) Media feed direction

(2) Cut position (I-mark sensor/Gap sensor)

Cut Position When Using the Media with Perforated Line in Cutter/Partial Cutter Mode

Adjust the cut position so as not to cut the media on the perforated line and on the area near side from

the perforated line (the area is shown in the figure below).