4 Operation and Configuration
Speed
Printing > Speed
The setting range of the print speed is as follows:
The setting range varies depending on the print resolution of the printer.
• 203 dpi: 2 to 10 ips (inch/sec)
• 305 dpi: 2 to 8 ips (inch/sec)
• 609 dpi: 2 to 6 ips (inch/sec)
Note:
If the print quality is not good, decrease the print speed.
Sensor Type
Printing > Sensor Type
Set the type of sensor for sensing the media.
The options are as follows:
• None: Disable the media sensor.
• Gap: Use the sensor of transmissive type.
• I-Mark: Use the sensor of reflective type.
If you have selected Tear-Off, Dispenser or Cut & Print in Print Mode,
only Gap and I-Mark is available in Sensor Type menu.
If you have selected Linerless in Print Mode, only None and I-Mark is
available in Sensor Type menu.
Auto-mode
Printing > Auto-mode
With the Auto-mode, the print mode changes automatically according to
the status of the installed option unit.
The options are as follows:
• Enabled: The print mode changes automatically.
• Disabled: The print mode changes according to the setting of the Print
Mode.
Operate in cutter mode if you have installed the cutter unit. However, oper-
ate in linerless mode when you have set Linerless in Print Mode. Operate
in dispenser mode if you have installed the dispenser unit.
70
CL4NX Operator Manual