Notes On The Stop/Cut Position Of Different Media - SATO CT4-LX Operator's Manual

Notes on the Stop/Cut Position of Different Media

Stop Position of the Label in Dispenser Mode
The regular position is to let the label stay about 2 ± 1 mm (0.08" ± 0.04") on the liner.
(1) Feed direction
(2) Dispenser bar
(3) Stop position
Cut Position When Using the Label in Tear-Off/Cutter Modes
The regular cut position is between labels (only cut on the liner).
When you cut the label, the glue adheres to the blade of the cutter and the blade will decrease the
performance of the cutter. Adjust the cut position so as not to cut the label.
(1) Feed direction
(2) Cut position (I-mark sensor/Gap sensor)
(3) Label
Notes on the Stop/Cut Position of Different Media
376