SATO CL4NX Operator's Manual page 127

Inputs
Interface > External I/O > Signals > Inputs
Set the input pin No. of Signal Print Start/Signal Reprint.
/
Press the arrow buttons to highlight the item that you want to
change and then press the
Press the button to save the settings and goes back to Signals menu.
The setting items are as follows:
1 Start Print
2 Reprint
Note:
You cannot set the any inputs with same input pin No. If do, the settings
will show in red and you cannot save the settings.
/
arrow buttons to change the pin No.
Set the input pin No. of Signal Print Start.
The options are as follows:
• IN_PIN5: Set the Signal Print Start to 5PIN.
• IN_PIN7: Set the Signal Print Start to 7PIN.
Set the input pin No. of Signal Reprint.
The options are as follows:
• IN_PIN5: Set the Signal Reprint to 5PIN.
• IN_PIN7: Set the Signal Reprint to 7PIN.
4 Operation and Configuration
CL4NX Operator Manual
125