SATO CL4NX Operator's Manual page 154

4 Operation and Configuration
Configure QR
Tools > Test Print > Configure QR
Print the configuration information with the QR code.
1. Check and set the items as listed on the Configure QR menu.
The setting items are as follows.
2. Press the right soft button to start the test print. Press the right soft but-
ton again to pause the print.
To stop the test print, first pause the print and then press the
1 Label Width
2 Label Length
3 Pitch
4 Offset
5 Darkness Adjust
152
CL4NX Operator Manual
Shows the necessary media width of the test
print.
The necessary media width is 50.8 mm (2") for
Small.
Set the length of one piece of media used for
the test print.
The setting range is as follows:
The setting range varies depending on the print
resolution of the printer.
• 203 dpi: 400 to 1600 dots
• 305 dpi: 600 to 1800 dots
• 609 dpi: 1200 to 3600 dots
Set the print position in the vertical direction.
The setting range is as follows:
The setting range varies depending on the print
resolution of the printer.
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi:-45 to 0 to 45 dots
• 609 dpi:-90 to 0 to 90 dots
When you decrease the setting value, the print
position moves toward the feed direction
(toward the front part of the media).
When you increase the setting value, the print
position moves away from the feed direction
(toward the end part of the media).
Set the stop position of the media.
The setting range is as follows:
The setting range varies depending on the print
resolution of the printer.
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi:-45 to 0 to 45 dots
• 609 dpi:-90 to 0 to 90 dots
When you decrease the setting value, the stop
position moves toward the feed direction
(toward the front part of the media).
When you increase the setting value, the stop
position moves away from the feed direction
(toward the end part of the media).
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
button.
Note:
The value of Label Length,
Pitch, Offset and Darkness
Adjust set in Configure QR
menu will reflect to the same
items setting in Factory
menu and Configure List
menu.