Removing The Liner From Rewinder - SATO CL4NX Operator's Manual

3 Installing Carbon Ribbon and Media
3
Remove about 80 cm (31.5") of labels 
from the liner , then pass the liner 
through the gap of the dispenser unit to
the inside of the printer.
4
Adjust the dispenser roller  to the center
of the label.
5
Pass the liner  below the liner rewinder
, then attach with the clip .
6
Turn the liner rewinder counter-
clockwise with hand to wind the liner.
7
Close the dispenser unit.
8
Close the print head and the top cover.
3.5.6

Removing the Liner from Rewinder

1
Pull the clip  away from the printer and
then pull to remove the liner .
2
Put the clip back to its initial position.
42
CL4NX Operator Manual
3
4
4
5
7
6
4
2
1