SATO CL4NX Operator's Manual page 152

4 Operation and Configuration
Factory
Tools > Test Print > Factory
Do the factory test print.
1. Check and set the items as listed on the Factory menu.
The setting items are as follows.
2. Press the right soft button to start the test print. Press the right soft but-
ton again to pause the print.
To stop the test print, first pause the print and then press the
1 Label Width
2 Pitch
3 Offset
4 Darkness Adjust
150
CL4NX Operator Manual
Shows the necessary media width of the test
print.
The necessary media width is 101.6 mm (4")
for Large.
Set the print position in the vertical direction.
The setting range is as follows:
The setting range varies depending on the print
resolution of the printer.
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi:-45 to 0 to 45 dots
• 609 dpi:-90 to 0 to 90 dots
When you decrease the setting value, the print
position moves toward the feed direction
(toward the front part of the media).
When you increase the setting value, the print
position moves away from the feed direction
(toward the end part of the media).
Set the stop position of the media.
The setting range is as follows:
The setting range varies depending on the print
resolution of the printer.
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi:-45 to 0 to 45 dots
• 609 dpi:-90 to 0 to 90 dots
When you decrease the setting value, the stop
position moves toward the feed direction
(toward the front part of the media).
When you increase the setting value, the stop
position moves away from the feed direction
(toward the end part of the media).
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
button.
Note:
The value of Pitch, Offset
and Darkness Adjust set in
Factory menu will reflect to
the same items setting in
Configure List menu and
Configure QR menu.