Cut Position Adjustment; Label Cut; Adjusting The Cut Position - SATO CG2 Series Quick Manual

CUT POSITION ADJUSTMENT

LABEL CUT

The label-cut position should be between labels or at the area with only the backing paper.

ADJUSTING THE CUT POSITION

If the cutting position is not at the regular position, use the Phillips tip of the potentiometer adjustment
screwdriver attached to the side of the paper holder to adjust the potentiometer for the cut position.
Do not cut directly on a label, as the label adhesive can stick to the cutter blade and adversely affect its cutting
ability.
CG2 Series Quick Guide
Label
Backing paper
Cut position
Potentiometer adjustment
screwdriver
Section 4: Cut Position Adjustment
Page 4-1