SATO CL4NX Operator's Manual page 10

Before You Start
Do not put in areas with high humidity
• Do not put the printer in areas with high
humidity or where condensation forms. If
condensation forms, immediately power
off the printer and do not use the printer
until it dries. Using the printer while
condensation is on could cause an
electric shock.
Carrying the Printer
• When moving the printer, always
disconnect the power cord from the
outlet and check to make sure all
external wires are disconnected before
moving it. Moving the printer with the
wires still connected could cause the
damage of the cords or connecting wires
and cause a fire or electrical shock.
• Do not carry the printer with media
loaded in it. The media could fall out and
cause an injury.
• When setting the printer on the floor or a
stand, make sure not to get your fingers
or hands pinched under the printer feet.
Power supply
• Do not operate the power switch,
connect the power cord or disconnect
the power cord with wet hands. Doing so
could cause an electric shock.
Power cord
• Keep the power cord away from hot
devices. Getting the power cord near hot
devices could cause the cord's covering
to melt and cause a fire or electrical
shock.
• When disconnecting the power cord from
the outlet, be sure to hold it by the plug.
Pulling it by the cord could expose or
break the core wires and cause a fire or
electric shock.
• The power cord set that comes with the
printer is especially made for this printer.
Do not use it with any other electrical
devices.
8
CL4NX Operator Manual
Caution
Top cover
• Be careful not to get your fingers pinched
when opening or closing the top cover.
Also be careful that the top cover does
not slip off and drop.
Loading media
• When loading media roll, be careful not
to get your fingers pinched between the
media roll and the supply unit.
When not using the printer for a long time
• When not using the printer for a long
time, disconnect the power cord from the
outlet to maintain safety.
During maintenance and cleaning
• When maintaining and cleaning the
printer, disconnect the power cord from
the outlet to maintain safety.