Chrysler 2005 Crossfire SRT6 Service Manual page 321

ZH
1100-LEFT FRONT WHEEL SPEED SENSOR CIRCUIT (CONTINUED)
5.
CHECK THE LEFT FRONT WHEEL SPEED SENSOR 12 VOLT SUPPLY CIRCUIT FOR A SHORT TO
VOLTAGE
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the voltage of the Left Front Wheel Speed Sensor 12 Volt
Supply circuit.
Is the voltage below 1.0 volt?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Repair the Left Front Wheel Speed Sensor 12 Volt Supply
circuit for a short to voltage.
Perform ABS VERIFICATION TEST.
6.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE LEFT FRONT WHEEL SPEED SENSOR 12
VOLT SUPPLY CIRCUIT
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Left Front Wheel
Speed Sensor 12 Volt Supply circuit at the CAB harness connector.
Is the resistance below 100k ohms?
Yes >> Repair the Left Front Wheel Speed Sensor 12 Volt Supply
circuit for a short to ground.
Perform ABS VERIFICATION TEST.
No >> Go to 7
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 155
ANTILOCK BRAKE -