Chrysler 2005 Crossfire SRT6 Service Manual page 392

5 - 226 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1140-ESP BRAKE PRESSURE SENSOR 1 CIRCUIT (CONTINUED)
11.
MEASURE THE RESISTANCE OF THE ESP BRAKE PRESSURE SENSOR 5-VOLT SUPPLY CIRCUIT
With the ignition off.
Measure the resistance of the 5-Volt Supply circuit from the ESP
Brake Pressure Sensor 1 harness connector to the CAB harness con-
nector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Repair the ESP Brake Pressure Sensor 5-Volt Supply cir-
cuit for an open.
Perform ABS VERIFICATION TEST.
ANTILOCK BRAKE -
ZH