Chrysler 2005 Crossfire SRT6 Service Manual page 341

ZH
1110-RIGHT FRONT WHEEL SPEED SENSOR CIRCUIT (CONTINUED)
11.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE RIGHT FRONT WHEEL SPEED SENSOR
SIGNAL CIRCUIT
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Right Front Wheel
Speed Sensor Signal circuit at the CAB harness connector.
Is the resistance below 100k ohms?
Yes >> Repair the Right Front Wheel Speed Sensor Signal circuit
for a short to ground.
Perform ABS VERIFICATION TEST.
No >> Go to 12
12.
MEASURE THE RESISTANCE BETWEEN THE RIGHT FRONT WHEEL SPEED SENSOR 12 VOLT
SUPPLY CIRCUIT AND THE SENSOR SIGNAL CIRCUIT
With the ignition off.
Measure the resistance between the Right Front Wheel Speed Sensor
12 Volt Supply circuit and the Right Front Wheel Speed Sensor Signal
circuit at the CAB harness connector.
Is the resistance below 100k ohms?
Yes >> Repair the Right Front Wheel Speed Sensor 12 Volt Sup-
ply circuit for a short to the Right Front Wheel Speed Sen-
sor Signal circuit.
Perform ABS VERIFICATION TEST.
No >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 175
ANTILOCK BRAKE -