Chrysler 2005 Crossfire SRT6 Service Manual page 338

5 - 172 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1110-RIGHT FRONT WHEEL SPEED SENSOR CIRCUIT (CONTINUED)
5.
CHECK THE RIGHT FRONT WHEEL SPEED SENSOR 12 VOLT SUPPLY CIRCUIT FOR A SHORT TO
VOLTAGE
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the voltage of the Right Front Wheel Speed Sensor 12 Volt
Supply circuit.
Is the voltage below 1.0 volt?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Repair the Right Front Wheel Speed Sensor 12 Volt Sup-
ply circuit for a short to voltage.
Perform ABS VERIFICATION TEST.
6.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE RIGHT FRONT WHEEL SPEED SENSOR 12
VOLT SUPPLY CIRCUIT
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between ground and the Right Front Wheel
Speed Sensor 12 Volt Supply circuit at the CAB harness connector.
Is the resistance below 100k ohms?
Yes >> Repair the Right Front Wheel Speed Sensor 12 Volt Sup-
ply circuit for a short to ground.
Perform ABS VERIFICATION TEST.
No >> Go to 7
ANTILOCK BRAKE -
ZH