Remove Timing Chain Case Oil Seal; Set No 1 Cylinder To Tdc/Compression - Toyota 2GR-FE Manual

Protective Tape
Protective Tape
Protective Tape
Wooden Block
Center Line
Timing Marks
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(b) Remove the timing chain cover by prying between
(c) Remove the 4 bolts, chain cover plate and gasket.
A129690E02
(d) Remove the gasket.
A128006E01

26. REMOVE TIMING CHAIN CASE OIL SEAL

(a) Using a screwdriver, pry out the oil seal.
27. SET NO. 1 CYLINDER TO TDC / COMPRESSION
(a) Temporarily tighten the pulley set bolt.
A108818E01
(b) Set the timing mark on the crank angle sensor plate
Sensor Plate
A129691E01
the timing chain cover and cylinder head or cylinder
block with a screwdriver.
NOTICE:
Be careful not to damage the contact surfaces of
the cylinder head, cylinder block and chain
cover.
HINT:
Tape the screwdriver tip before use.
HINT:
Tape the screwdriver tip before use.
to the RH block bore center line (TDC /
compression).
EM–73
EM