Toyota 2GR-FE Manual page 266

ES–110
OK
6
INSPECT OIL CONTROL VALVE FILTER AND PIPE
RH Bank:
ES
LH Bank:
OK
7
REPLACE EXHAUST CAMSHAFT
NEXT
8
CHECK WHETHER DTC OUTPUT RECURS
2GR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM
NG
(a) Remove the oil pipe No. 1 or No. 2.
(b) Remove the oil control valve filter.
(c) Check that the filter and pipe are not clogged.
OK:
Filter is not clogged.
NG
G042497E01
(a) Clear the DTCs.
(1) Operate the intelligent tester, or disconnect the EFI
(b) Start the engine and warm up the engine.
(c) Switch the ECM from normal mode to check mode using
the intelligent tester (See page ES-49).
(d) Drive the vehicle for more than 10 minutes or more.
(e) Read the output DTCs using the intelligent tester.
OK:
No DTC output.
REPLACE CAMSHAFT TIMING OIL
CONTROL VALVE ASSEMBLY (See page
481)
CLEAN OIL CONTROL VALVE FILTER AND
PIPE
and ETCS fuses more than 60 seconds to erase the
codes.
ES-