Toyota 2GR-FE Manual page 756

(*3)
(*3)
(*1)
Fuel Tube Connector
2GR-FE FUEL – FUEL TANK
(c) Install the 2 fuel tank bands with the 2 pins.
(d) Set the fuel tank assembly onto the transmission
jack.
A129491
(e) Raise the transmission jack so that the fuel tank
vent hose can be connected. (*1)
NOTICE:
Slowly raise the jack to prevent the fuel tank
assembly from dropping.
(f) Connect the fuel tank inlet pipe with the fuel filter
pipe clamp. (*2)
(g) Tighten the 2 set bolts of the fuel tank bands. (*3)
Torque: 39 N*m (400 kgf*cm, 29 ft.*lbf)
(*2)
A129492E02
(h) Connect the No. 1 fuel tube.
(1) Push the fuel tube connector into the pipe until
Pipe
A091572E03
(i) Connect the fuel pump tube.
(1) Push the fuel tube connector into the pipe and
Retainer
A081598E03
the fuel tube connector makes a "click" sound.
NOTICE:
• Before connecting the tube, make sure
that it is not damaged. Make sure that
there is no dirt present on the connecting
surfaces.
• After connecting, check if the fuel tube
connector and the pipe are securely
connected by pulling on them.
push up the retainer so that the claws engage.
NOTICE:
• Before connecting the tube, make sure
that it is not damaged. Make sure that
there is no dirt present on the connecting
surfaces.
FU–43
FU