Remove Water Inlet Pipe/Valve Stem Cap/Intake Valve/Exhaust Valve - Toyota 2GR-FE Manual

2GR-FE ENGINE MECHANICAL – ENGINE UNIT
1 8 6
3 5 7
SST
SST
(b) Using a 10 mm bi-hexagon wrench, uniformly
loosen the 8 bolts in the sequence shown in the
4
illustration. Remove the 8 cylinder head bolts and
plate washers.
NOTICE:
• Be careful not to drop washers into the
cylinder head.
• Cylinder head warpage or cracking could
result from removing bolts in an incorrect
2
order.
A129711E01
HINT:
Be sure to keep separate the removed parts for
each installation position.
(c) Remove the cylinder head and gasket.
51. REMOVE WATER INLET PIPE
(a) Separate the No. 1 water by-pass hose.
(b) Remove the 2 bolts and water inlet pipe.
52. REMOVE VALVE STEM CAP
(a) Remove the valve stem caps from the cylinder
heads.
HINT:
Arrange the removed parts in the correct order.
A129713
53. REMOVE INTAKE VALVE
(a) Using SST, compress the compression spring and
remove the valve spring retainer locks.
SST
(b) Remove the retainer, compression spring and valve.
HINT:
Arrange the removed parts in the correct order.
A129714E01
54. REMOVE EXHAUST VALVE
(a) Using SST, compress the compression spring and
remove the valve spring retainer locks.
SST
(b) Remove the retainer, compression spring and valve.
HINT:
Arrange the removed parts in the correct order.
A129715E01
09202-70020 (09202-00010)
09202-70020 (09202-00010)
EM–81
EM