Toyota 2GR-FE Manual page 481

6
CHECK HARNESS AND CONNECTOR
Wire Harness Side:
Transmission Control Switch
E31
OK
7
INSPECT TRANSMISSION CONTROL SWITCH
Component Side:
Transmission Control Switch
E31
OK
2GR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM
(a) Disconnect the transmission control switch connector of
the shift lock control unit assembly.
(b) Turn the ignition switch on (IG).
(c) Measure the voltage between the terminals.
Standard voltage
(d) Reconnect the transmission control switch connector.
NG
C110345E20
(a) Measure the resistance according to the value(s) in the
table below when the shift lever is moved to each
position.
Standard resistance
Shift Position
S, ''+'' and ''-''
Except S, ''+'' and ''-''
NG
C136860E03
Tester Connection
3 - Body ground
REPAIR OR REPLACE HARNESS OR
CONNECTOR
Tester Connection
3 - 7
REPLACE TRANSMISSION CONTROL
SWITCH
ES–325
Specified Condition
10 to 14 V
ES
Specified Condition
Below 1 Ω
10 kΩ or higher