Replace Crankshaft Rear Oil Seal - Toyota 7M-GE Repair Manual

ENGINE :MECHANICAL.;:y Cylinder, B&k:
Elg781i.
.,. ,.,. .._. >,, \I . ,_ ". 1 . , ,_ ., "_ , ; . . .
EM2994
SST
(b) Apply MP grease to a new oil, seal lip.
(~1, Using--SST and a hammer, tap in-the oil seal.
SST 09214-60010 and 09506-3501.0 ;"
.
2. REPLACE CRANKSHAFT REAR OIL SEAL
'-. '. :
A. If the rear oil seal retainer is removed from the,
cylinder block: ': <
.:
(a) Using a screwdriver and hammer, tap out the oil seal.
(b) Using SST and a hammer, tap in a new oil seal.
SST 09223-41020
(cl Apply MP grease to the oil seal lip.
8. If the rear oil seal retainer is installed to the
cylinder block:
(a) :Using a knife, cut off the lip of the oil seal as shown.
(b) Using a screwdriver, pry out the oil seal.
CAUTION: Be careful not to damage the crankshaft.
Tape the screwdriver tip.
(c) Check the oil seal lip contact surface of the
crankshaft for cracks or damage.
(d)
Apply MP grease to a new oil seal lip.
(e)
Using SST and a hammer, tap in the oil seal.
SST 09223-41020