Toyota 2GR-FE Manual page 145

EM–144
EM
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
A
A129675E01
Bolt length
Item
Bolt A
Bolt B
Bolt C
NOTICE:
Make sure that there is no oil on the bolt
threads.
(f) Fully tighten the bolts in this order: Area 1 and Area
2.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
(g) Fully tighten the bolts and nuts in this order: Area 3.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
HINT:
Tighten the bolts and nuts in the order of upper to
lower as shown in the illustration.
(h) Fully tighten the bolts in this order: Area 4.
Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf) for bolt A
21 N*m (214 kgf*cm, 15 ft.*lbf) for bolts
except bolt A
HINT:
Tighten the bolts in the order of lower to upper as
shown in the illustration.
(i) Install a new gasket and the chain cover plate with
the 4 bolts.
Torque: 9.1 N*m (93 kgf*cm, 81 in.*lbf)
48. INSTALL WATER INLET HOUSING
(a) Install 2 new O-rings.
HINT:
Apply a small amount of water or soapy water to O-
ring (A) in the illustration before installing it.
Length
40 mm (1.57 in.)
55 mm (2.17 in.)
25 mm (0.98 in.)