Engine Assembly Inspection; Remove Engine Coolant Temperature Sensor - Toyota 2GR-FE Manual

EM–36
EM
2GR-FE ENGINE MECHANICAL – ENGINE ASSEMBLY
89. REMOVE ENGINE COOLANT TEMPERATURE
SENSOR
(a) Using a 19 mm deep socket wrench, remove the
A129648
INSPECTION
1. INSPECT EXHAUST MANIFOLD SUB-ASSEMBLY LH
(a) Using a precision straightedge and feeler gauge,
A134936
2. INSPECT EXHAUST MANIFOLD SUB-ASSEMBLY RH
(a) Using a precision straightedge and feeler gauge,
A134937
3. INSPECT INTAKE AIR SURGE TANK ASSEMBLY
(a) Using a precision straightedge and feeler gauge,
A134935
EFI engine coolant temperature sensor and gasket.
measure the warpage on the contact surface of the
cylinder head.
Maximum warpage:
0.7 mm (0.028 in.)
HINT:
The maximum allowable warpage of each
installation surface is 0.3 mm (0.012 in.).
If the warpage is greater than the maximum, replace
the manifold.
measure the warpage on the contact surface of the
cylinder head.
Maximum warpage:
0.7 mm (0.028 in.)
HINT:
The maximum allowable warpage of each
installation surface is 0.3 mm (0.012 in.).
If the warpage is greater than the maximum, replace
the manifold.
measure the warpage on the contact surface of the
intake manifold.
Maximum warpage:
2.5 mm (0.098 in.)
If the warpage is greater than the maximum,
replace the surge tank.