Toyota 2GR-FE Manual page 130

Lot No.
Engine Front
4
7 2
1
5 3
90°
Engine Front
Painted Mark
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
25. INSTALL WATER INLET PIPE
(a) Install the water inlet pipe with the 2 bolts.
(b) Install the water by-pass hose No. 1.
A120668
26. INSTALL CYLINDER HEAD SUB-ASSEMBLY RH
(a) Place the cylinder head gasket on the cylinder block
(b) Place the cylinder head on the cylinder block.
A131898E01
(c) Apply a light coat of engine oil to the threads and
(d) Step 1
6
8
A129712E02
(e) Step 2
90°
(f)
A035289E02
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
surface with the Lot No. stamp upward.
NOTICE:
• Be careful of the installation direction.
• Gently place the cylinder head in order not to
damage the gasket with the bottom part of the
head.
NOTICE:
Be careful not to allow oil to adhere to the
bottom part of the cylinder head.
HINT:
The cylinder head bolts are tightened in 3
progressive steps.
under the heads of the cylinder head bolts.
(1) Using a 10 mm bi-hexagon wrench, install and
uniformly tighten the 8 cylinder head bolts with
the plate washers in several steps and in the
sequence shown in the illustration.
Torque: 36 N*m (367 kgf*cm, 27 ft.*lbf)
(1) Mark the cylinder head bolt head with paint as
shown in the illustration.
(2) Tighten the cylinder head bolts another 90°.
Step 3
(1) Tighten the cylinder head bolts by an additional
90°.
(2) Check that the painted mark is now facing
rearward.
EM–129
EM