Toyota 2GR-FE Manual page 921

MAIN BODY:
Item
STSW1
START SW2
NG
2
CHECK ENGINE SWITCH CONDITION
OK
END
3
INSPECT ENGINE SWITCH
START
STOP
2GR-FE STARTING – SMART KEY SYSTEM
Measurement Item/Display
(Range)
Start Switch 1/ON or OFF
Start Switch 2/ON or OFF
OK:
ON (engine switch on (IG)) and OFF (engine switch
off) appear on the screen.
OK
(a) Check the power source mode change.
(1) When the key is inside the vehicle and the shift lever
NG
(a) Remove the engine switch.
(b) Disconnect the switch connector.
Normal Condition
ON: Engine switch on (IG)
OFF: Engine switch off
ON: Engine switch on (IG)
OFF: Engine switch off
Go to step 3
is in the P position, check that pressing the engine
switch causes the power source mode to change as
follows:
OK:
off → on (ACC) → on (IG) → off
HINT:
• If power mode does not change to ON (IG and
ACC) (See page ST-114).
• If power mode does not change to ON (IG) (See
page ST-122).
• If power mode does not change to ON (ACC)
(See page ST-131).
GO TO OTHER PROBLEM
SS1 GND SS2
7 6 5 4 3 2
14 13 12 11 10 9
ST–59
Diagnostic Note
-
-
1
8
A109252E01
ST