Toyota 2GR-FE Manual page 717

FU–4
Quick Type B
Quick Type B
FU
Quick Type B
Plastic Bag
Quick Type B
2GR-FE FUEL – FUEL SYSTEM
(f) Observe the following precautions when
disconnecting the fuel tube connector (Quick type
B):
(1) Before disconnecting the connector, clean off
any dirt that may be present.
(2) Pinch the tabs of the fuel tube retainer to
disengage the 2 claws. Push the retainer down
as shown in the illustration.
HINT:
Be sure to disconnect the connector by hand.
A129459E01
(3) If the connector and pipe are stuck, hold the fuel
pipe by hand, and push and pull on the
connector. Pull the two pipes apart to separate
the connector.
(4) If there is any dirt or any other foreign objects on
the sealing surfaces of the disconnected pipes,
clean them if necessary.
A091246E06
(5) Do not damage the disconnected pipe and
connector, and prevent entry of foreign objects
by covering them with a plastic bag.
A093309E03
(g) Observe the following precautions when connecting
the fuel tube connector (Quick Type B):
(1) Line up the two parts of the pipes to be
connected, and fully push the fuel tube
connector and pipe together until they are fully
seated. Next, push the retainer into the
connector until its claws lock. If the pipe is
difficult to push in to the connector, apply a small
amount of clean engine oil to the tip of the pipe
and reinsert it.
A132390E01
(2) After connecting the pipes, check that the pipe
and connector are securely connected by pulling
on them.
(3) Check for fuel leaks.
(h) Observe the following precautions when handling a
nylon tube:
CAUTION:
• Do not twist the connection part of the nylon
tube and the quick connector when
connecting them.
• Do not bend or twist the nylon tube.