Toyota 2GR-FE Manual page 972

ST–110
SMART ACCESS (Certification ECU):
Item
L CODE CHK
OK
22
READ VALUE OF INTELLIGENT TESTER (ENGINE START REQUEST)
SMART ACCESS (Certification ECU):
Item
START RQST
OK
23
READ VALUE OF INTELLIGENT TESTER (S CODE)
ST
SMART ACCESS (Certification ECU):
Item
S CODE CHK
2GR-FE STARTING – SMART KEY SYSTEM
(c) Turn the engine switch on (IG).
Measurement Item/Display
(Range)
L code check / ON or NG
OK:
OK is displayed on the screen.
HINT:
If the result is not as specified, there may be a
malfunction with the steering lock ECU or the ID code
box.
NG
(a) Connect the intelligent tester to the DLC3.
HINT:
When using the intelligent tester with the engine switch
off, turn on and off any of the door courtesy light switches
repeatedly at 1.5 second intervals or less until
communication between the tester and vehicle starts.
(b) Turn the engine switch on (IG).
Measurement Item/Display
(Range)
Start request signal response /
OK or NG
OK:
OK (received) and NG (not received) appear on the
screen.
NG
(a) Connect the intelligent tester to the DLC3.
HINT:
When using the intelligent tester with the engine switch
off, turn on and off any of the door courtesy light switches
repeatedly at 1.5 second intervals or less until
communication between the tester and vehicle starts.
(b) Turn the engine switch on (IG).
Measurement Item/Display
(Range)
S code check / OK or NG
Normal Condition
OK: Normal
NG: Malfunction
GO TO ENGINE IMMOBILISER SYSTEM
Normal Condition
OK: Received
NG: Not received
REPLACE CERTIFICATION ECU
Normal Condition
OK: Normal
NG: Malfunction
Diagnostic Note
Electrical key in the cabin
Diagnostic Note
-
Diagnostic Note
-