Toyota 2GR-FE Manual page 134

4
3
8 7
1 3
5
6
2 4
Valve Rocker Arm
Lash
Adjuster
Valve Stem
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(d) Tighten the 8 bolts in the order shown in the
1
2
32. INSTALL CAMSHAFT BEARING CAP (for Bank 2)
(a) Apply engine oil to the camshaft journals, camshaft
(b) Install the No. 3 camshaft and No. 4 camshaft to the
6 5
A129701E02
(c) Make sure of the marks and numbers on the
A134960
(d) Temporarily tighten the 8 bolts in the order shown in
7
8
A132217E01
33. INSTALL CAMSHAFT HOUSING SUB-ASSEMBLY LH
(a) Make sure that the valve rocker arm is installed as
Valve Stem Cap
A131901E01
• If the camshaft housing is removed because
any of the bolts are loosened during
installation, make sure that the previously
applied seal packing does not enter any oil
passages.
illustration.
Torque: 16 N*m (163 kgf*cm, 12 ft.*lbf)
housing and bearing caps.
camshaft housing LH.
camshaft bearing caps and place them in each
proper position and direction.
the illustration.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
shown in the illustration.
EM–133
EM