Toyota 2GR-FE Manual page 860

CH–22
SST (B)
100 mm (3.937 in.)
CH
2GR-FE CHARGING – GENERATOR
(f) Tighten the pulley by turning SST (B) in the direction
shown in the illustration.
Torque: 111 N*m (1,125 kgf*cm, 81 ft.*lbf)
NOTICE:
The torque shown above should be used for
tightening without using the SST. When the SST
is used for tightening, the torque should be
calculated based on the length of the SST (See
page IN-6).
(g) Remove the generator assembly from the SST.
(h) Check that the clutch pulley rotates smoothly.
(i) Install a new clutch pulley cap to the clutch pulley.
A135208E01
INSTALLATION
1. INSTALL GENERATOR ASSEMBLY
(a) Install the bracket with the bolt.
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
A135391
(b) Install the wire harness clamp stay.
Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf)
A128066
(c) Connect the wire harness clamp.
(d) Install the generator assembly to the cylinder block
with the bolt.
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
A133867