Toyota 2GR-FE Manual page 129

EM–128
SST
EM
: Seal Packing
A
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
A131894
A120675E01
2.0 to 3.0
(0.079 to
0.118)
mm (in.)
A131897E02
A
A129686E01
(d) Using a plastic hammer, lightly tap the valve stem
tip to ensure a proper fit.
NOTICE:
Be careful not to damage the retainer.
22. INSTALL VALVE STEM CAP
(a) Apply a light coat of engine oil to the valve stem
caps.
(b) Install the valve stem caps on the valves.
23. INSTALL ENGINE REAR OIL SEAL
(a) Place the oil seal retainer on wooden blocks.
(b) Using SST, tap in a new oil seal until its surface is
flush with the oil seal retainer edge.
SST 09223-15030, 09950-70010 (09951-07100)
NOTICE:
• Keep the lip free of foreign matter.
• Do not tap on the oil seal at an angle.
24. INSTALL ENGINE REAR OIL SEAL RETAINER
(a) Apply seal packing in a continuous line as shown in
the illustration.
Seal packing:
Toyota Genuine Seal Packing Black, Three
Bond 1207B or equivalent
Seal Diameter:
2.0 to 3.0 mm (0.079 to 0.118 in.)
NOTICE:
• Remove any oil from the contact surface.
• Install the oil seal retainer within 3 minutes
after applying seal packing.
• Do not start the engine for at least 2 hours
after installation.
(b) Install the oil seal retainer with the 6 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTICE:
Be sure to apply adhesive 1324 to the bolts in
the places indicated by A before installing them.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond
1324 or Equivalent