Toyota 2GR-FE Manual page 796

3
5
1
6 4
SST
Stopper Bolt
2GR-FE COOLING – RADIATOR
(d) Lightly press SST against the lock plate in the order
7
2
8
Lock Plate
Tank
A129608E02
(e) Check the lock plate height (H) after completing
(f)
H
3. INSTALL RADIATOR TANK LOWER
A128142E01
(a) Installation procedure of the radiator tank lower is
(b) With hose
4. INSTALL DRAIN PLUG
(a) Install a new O-ring to the drain plug.
(b) Install the drain plug.
A134968E02
shown in the illustration. After repeating this a few
times, fully caulk the lock plate by gripping the
handle until stopped by the stopper plate.
HINT:
• Do not tap the areas protruding around the pipes,
brackets or tank ribs.
• The dotted circles shown in the illustration and
parts of the oil cooler near the dotted circles
cannot be tapped with the SST. Use pliers or
similar objects and be careful not to damage the
core plates.
caulking.
Plate height (H):
7.40 to 7.80 mm (0.2913 to 0.3071 in.)
If not within the specified height range, adjust the
stopper bolt of the handle and caulk again.
Tap the lock plate with a soft-faced hammer so that
there is no gap between the lock plate and the tank.
the same as that of the radiator tank upper.
(1) Install the hose and 2 clips.
CO–31
CO