Inspect Camshaft Timing Gear Assembly - Toyota 2GR-FE Manual

Key Groove
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(c) Using a micrometer, measure the journal diameter.
Item
No. 1 journal
Other journals
4.

INSPECT CAMSHAFT TIMING GEAR ASSEMBLY

A109633
(a) Clamp the camshaft in a vise.
(b) Put the camshaft timing gear and camshaft together
Straight Pin
(c) Lightly press the gear against the camshaft, and
(d) Check that there is no clearance between the gear's
A109635E02
(e) Tighten the flange bolt with the camshaft timing gear
(f)
A109634
Standard journal diameter
35.946 to 35.960 mm (1.4152 to 1.4157 in.)
25.959 to 25. 975 mm (1.0220 to 1.0226 in.)
If the journal diameter is not as specified, check the
oil clearance.
NOTICE:
Be careful not to damage the camshaft in the
vise.
by aligning the key groove and straight pin.
turn the gear. Push further at the position where the
pin enters the groove.
NOTICE:
Be sure not to turn the camshaft timing gear in
the retard direction (the right angle).
flange and the camshaft.
fixed.
Torque: 100 N*m (1,020 kgf*cm, 74 ft.*lbf)
Check the lock of the camshaft timing gear.
(1) Clamp the camshaft in a vise, and confirm that
the camshaft timing gear is locked.
NOTICE:
Be careful not to damage the camshaft.
EM–89
Specification
EM