Toyota 2GR-FE Manual page 121

EM–120
Vernier Calipers
EM
No. 2 Ring
Front Mark
Oil Ring
Expander
No. 1 Ring
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
A B
A094752E02
Side Rail Lower
Side Rail Upper
A131881E01
(n) Check the crankshaft thrust clearance (See page
EM-104).
9. INSTALL CONNECTING ROD BEARING
(a) Install the connecting rod bearing to the connecting
rod and bearing cap.
(b) Using vernier calipers, measure the distance
between the connecting rod's and bearing cap's
edges and the connecting rod bearing's edge.
Dimension (A - B):
0.7 mm (0.0276 in.) or less
NOTICE:
Do not apply engine oil to the bearings and the
contact surfaces.
10. INSTALL PISTON SUB-ASSEMBLY WITH
CONNECTING ROD
(a) Apply engine oil to the cylinder walls, the pistons,
and the surfaces of the connecting rod bearings.
(b) Position the piston rings so that the ring ends are as
shown in the illustration.
NOTICE:
Do not align the ring ends.