Toyota 2GR-FE Manual page 752

Pinch
Pull
Pinch
Tube Connector
Nylon Tube
O-Ring
2GR-FE FUEL – FUEL TANK
• If the pipe and connector are stuck, try
(b) Disconnect the No. 1 fuel tube.
(1) Pinch the tube connector and then pull out the
No. 1 fuel tube.
NOTICE:
• Check that there is no dirt or other
• It is necessary to prevent mud or dirt
• Remove the quick connector by hand.
• Do not bend or twist the nylon tube.
• If the pipe and connector are stuck, try
Pipe
A121576E01
(c) Place a engine lifter under the fuel tank assembly.
A136009
wiggling or pushing and pulling the
connector to release it and pull the
connector off of the pipe carefully.
foreign objects around the connector
before this operation and clean the
connector as necessary.
from entering the quick connector. If mud
enters the connector, the O-rings may
not seal properly.
Protect the connector by covering it with
a plastic bag.
wiggling or pushing and pulling the
connector to release it and pull the
connector off of the pipe carefully.
FU–39
FU