Toyota 2GR-FE Manual page 150

3.0 to 4.0 mm
(0.118 to 0.156 in.)
: Seal Packing
Nut
: Seal Packing
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(b) Apply seal packing in a continuous line as shown in
A132234E02
(c) Install the oil pan with the 16 bolts and 2 nuts.
Nut
A129680E01
54. INSTALL OIL PAN DRAIN PLUG
(a) Install a new gasket and the drain plug.
A129654
55. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
(for Bank 1)
(a) Apply seal packing as shown in the illustration.
A132236E01
the illustration.
Seal packing:
Toyota Genuine Seal Packing Black, Three
Bond 1207B or equivalent
Seal diameter:
3.0 to 4.0 mm (0.118 to 0.156 in.)
NOTICE:
• Remove any oil from the contact surface.
• Install the oil pan No. 2 within 3 minutes after
applying seal packing.
• Do not start the engine for at least 2 hours
after installing.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)
Seal packing:
Toyota Genuine Seal Packing Black, Three
Bond 1207B or equivalent
NOTICE:
• Remove any oil from the contact surface.
• Install the head cover within 3 minutes after
applying seal packing.
• Do not start the engine for at least 2 hours
after installing.
EM–149
EM