Toyota 2GR-FE Manual page 740

Tube Joint Clip
Fuel Tube Joint
O-Ring
Tube Joint Clip
2GR-FE FUEL – FUEL PUMP
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
HINT:
See page FU-1.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
3. REMOVE REAR SEAT CUSHION ASSEMBLY (for
Fixed Seat Type) (See page SE-77)
4. REMOVE REAR SEAT CUSHION ASSEMBLY (for
Fold Down Seat Type) (See page SE-47)
5. REMOVE REAR SEAT CUSHION ASSEMBLY (for
Reclining Seat Type) (See page SE-62)
6. REMOVE REAR FLOOR SERVICE HOLE COVER
(a) Remove the rear floor service hole cover.
(b) Disconnect the fuel pump connector.
A129478
7. SEPARATE FUEL PUMP TUBE SUB-ASSEMBLY
(a) Remove the tube joint clip, and pull out the fuel
pump tube.
NOTICE:
• Check that there is no dirt around the fuel
• It is necessary to prevent mud or dirt from
• Do not use any tools in this work.
• Do not bend or twist the nylon tube.
• After disconnecting, cover the fuel tube joint
• If the fuel tube joint and fuel suction plate are
Fuel Tube
A136246E01
tube joint before this work and clean any dirt
away.
entering the fuel tube joint. If mud enters the
joint, the O-rings may not seal the fuel tube
connector and fuel suction plate properly.
with a plastic bag.
stuck, pinch the fuel tank tube between
fingers, and turn it carefully to release.
Disconnect the fuel tank tube.
FU–27
FU