Toyota 2GR-FE Manual page 622

ES–466
6
INSPECT PARK/NEUTRAL SWITCH ASSEMBLY
Component Side:
C1
Park / Neutral Position Switch
ES
OK
CHECK HARNESS AND CONNECTOR
7
INSPECT STARTER RELAY
OK
2GR-FE ENGINE CONTROL SYSTEM – SFI SYSTEM
(a) Inspect the Park / Neutral Position (PNP) switch.
(1) Disconnect the C1 switch connector.
(2) Measure the resistance according to the value(s) in
Gear Selector Lever
(3) Reconnect the PNP switch connector.
NG
A107908E03
(a) Remove the ST relay from the engine room R/B.
(b) Measure the resistance between the terminals.
Standard resistance
Tester Connection
(c) Reinstall the ST relay.
B016200E02
NG
the table below.
Standard resistance
Tester Connection
Position
P 4 - 5
N 4 - 5
REPLACE PARK/NEUTRAL POSITION
SWITCH ASSEMBLY (See page AX-174)
3 - 5
3 - 5
(when battery voltage applied to terminals 1 and 2)
REPLACE STARTER RELAY
Specified Condition
Below 1 Ω
Below 1 Ω
Specified Condition
10 kΩ or higher
Below 1 Ω