Toyota 2GR-FE Manual page 686

ES–518
ES
Lock
Push
2GR-FE ENGINE CONTROL SYSTEM – ECM
REMOVAL
1. REMOVE WINDSHIELD WIPER ARM AND BLADE
ASSEMBLY LH (See page WW-9)
2. REMOVE WINDSHIELD WIPER ARM AND BLADE
ASSEMBLY RH (See page WW-9)
3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
(See page WW-9)
4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
(See page WW-9)
5. REMOVE COWL TOP VENTILATOR LOUVER SUB-
ASSEMBLY (See page WW-10)
6. REMOVE WINDSHIELD WIPER MOTOR AND LINK
(See page WW-10)
7. REMOVE COWL TOP OUTER PANEL SUB-
ASSEMBLY (See page ES-481)
8. REMOVE ECM
(a) Remove the 3 nuts.
A135711
(b) Disconnect the 2 ECM connectors and remove the
ECM.
(1) Raise the 2 levers while pushing the locks on
A128952E01
(2) Remove the ECM.
the 2 levers, and disconnect the 2 ECM
connectors.
NOTICE:
After disconnecting the connector, make
sure that dirt, water and other foreign
matter do not contact the connecting part of
the connector.