Toyota 2GR-FE Manual page 146

2GR-FE ENGINE MECHANICAL – ENGINE UNIT
9 mm (0.35 in.)
25 mm
(0.98 in.)
9 mm (0.35 in.)
Nut
10° 10°
(b) Install the stud bolts.
Torque: 4.0 N*m (41 kgf*cm, 35 in.*lbf)
A137975E01
(c) Install the water inlet with the 2 bolts and nut.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTICE:
Be careful that the O-ring does not get caught
between the parts.
(d) Connect the water by-pass hose No. 1.
(e) Apply adhesive around the drain cock.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond
1324 or Equivalent
A134879E01
(f) Install the housing drain cock to the water inlet
housing.
Torque: 30 N*m (306 kgf*cm, 22 ft.*lbf)
(g) Install the housing plug to the water drain cock.
Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
(h) Install a new gasket to the thermostat.
(i) Align the thermostat jiggle valve with the upper stud
bolt, and insert the thermostat in the water inlet
housing.
HINT:
The jiggle valve may be set within 10° of either side
of the prescribed positions.
A134896E01
EM–145
EM