Toyota 2GR-FE Manual page 116

80°C (176°F)
Front Mark
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(b) Gradually heat the piston to approximately 80°C
(c) Coat the piston pin with engine oil.
A125895E02
(d) Align the front marks of the piston and connecting
A131878E01
(e) Check the fitting condition between the piston and
A107551
(f)
Service Hole
5. INSTALL PISTON RING SET
(a) Install the oil ring expander and 2 side rails by hand.
A131879E01
(176°F).
rod, and push in the piston pin with your thumb.
HINT:
The piston and pin are a matched set.
piston pin by trying to move the piston back and
forth on the piston pin.
Using a screwdriver, install a new snap ring at the
other end of the piston pin hole.
HINT:
Be sure that the end gap of the snap ring is not
aligned with the pin hole cutout portion of the piston.
EM–115
EM