Remove Crankshaft Pulley/Timing Chain Case Oil Seal - Toyota 2GR-FE Manual

2GR-FE ENGINE MECHANICAL – ENGINE FRONT OIL SEAL
SST
SST
Cut Position
REMOVAL
1. REMOVE FRONT WHEEL RH
2. REMOVE FRONT FENDER APRON SEAL RH
3. REMOVE V-BANK COVER SUB-ASSEMBLY (See
page EM-23)
4. REMOVE V-RIBBED BELT (See page EM-6)
5. REMOVE CRANKSHAFT PULLEY
(a) Using SST, loosen the crankshaft pulley bolt.
SST
A119083E01
(b) Using SST, remove the crankshaft pulley bolt and
SST
A119085E01
6. REMOVE TIMING CHAIN CASE OIL SEAL
(a) Using a screwdriver, pry out the oil seal.
Protective Tape
A132241E01
SST 09213-70011 (09213-70020), 09330-00021
crankshaft pulley.
SST 09950-50013 (09951-05010, 09952-05010,
09953-05020, 09954-05021)
HINT:
Tape the screwdriver tip before use.
NOTICE:
After the removal, check the crankshaft for
damage. If it is damaged, smooth the surface
with 400-grit sandpaper.
EM–9
EM