Toyota 2GR-FE Manual page 701

Closed
Valve
7 6
2GR-FE EMISSION CONTROL – CANISTER
(3) Connect the positive (+) lead to terminal 7 and
(4) Check that the valve is closed.
(5) Install the detection pump.
A128109E01
INSTALLATION
1. INSTALL CHARCOAL CANISTER ASSEMBLY
(a) Install the 2 bolts, clip and charcoal canister.
Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf)
(b) Connect the purge line hose to the charcoal
canister.
(c) Connect the wire harness clamp.
(d) Connect the vapor pressure sensor connector.
(e) Connect the charcoal canister filter sub-assembly to
the charcoal canister.
(f) Connect the fuel tank vent hose to the charcoal
canister.
2. INSTALL FUEL TANK ASSEMBLY
HINT:
A128096
(See page FU-41)
the negative (-) lead to terminal 6.
If the result is not as specified, replace the
charcoal canister assembly.
EC–11
EC