Toyota 2GR-FE Manual page 118

CORRECT
Vernier Calipers
Mark 1, 2, 3, 4 or 5
Oil Grooves
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(b) Install the upper bearing.
Upper
Bearing
INCORRECT
A094746E04
(c) Install the lower bearing.
7. INSTALL CRANKSHAFT THRUST WASHER SET
(a) Apply engine oil to the crankshaft thrust washer.
A131826E01
(b) Install the 2 thrust washers under the No. 2 journal
8. INSTALL CRANKSHAFT
(a) Apply engine oil to the upper bearing, then place the
A106233E02
(1) Install the upper bearings to the cylinder block
as shown in the illustration.
NOTICE:
• Do not apply engine oil to the bearings
and the contact surfaces.
• Both sides of the oil groove in the
cylinder block should be visible through
the oil feed holes in the bearing. The
amount visible on each side of the holes
should be equal.
(1) Install the lower bearings to the bearing caps.
(2) Using vernier calipers, measure the distance
between the bearing cap's edge and the lower
bearing's edge.
Dimension (A - B):
0.7 mm (0.0276 in.) or less
NOTICE:
Do not apply engine oil to the bearings and
the contact surfaces.
position of the cylinder block with the oil grooves
facing outward.
crankshaft on the cylinder block.
EM–117
EM