Toyota 2GR-FE Manual page 124

Protrusion Height
RH Bank:
LH Bank:
2.5 to 3.5 mm
(0.098 to 0.138 in.)
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(b) Heat the cylinder head to 80 to 100°C (176 to
(c) Place the cylinder head on wooden blocks.
(d) Using SST, tap in new valve guide bushes to the
SST
A120712E04
(e) Using a sharp 5.5 mm reamer, ream the valve guide
A096429
13. INSTALL RING PIN
(a) Using a plastic hammer, tap in new ring pins to the
A131888E01
If the bush bore diameter of the cylinder head is
greater than 10.306 mm (0.4057 in.), machine the
bush bore to the dimension of 10.335 to 10.356 mm
(0.4069 to 0.4077 in.) to install a O/S 0.05 valve
guide bush.
If the bush bore diameter of the cylinder head is
greater than 10.356 mm (0.4077 in.), replace the
cylinder head.
212°F).
specified protrusion height.
SST 09201-10000 (09201-01050), 09950-70010
(09951-07100)
Protrusion height:
9.30 to 9.70 mm (0.3661 to 0.3819 in.)
bushings to obtain the specified clearance.
Standard oil clearance:
0.030 to 0.065 mm (0.0012 to 0.0026 in.)
specified protrusion height.
Specified protrusion height:
2.5 to 3.5 mm (0.098 to 0.138 in.)
EM–123
EM