Toyota 2GR-FE Manual page 137

EM–136
Plunger
Pin
Timing Marks
EM
Turn
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
Push
A121266E02
Mark Plate
A124049E03
Hold
A121641E02
A120649
36. INSTALL NO. 3 CHAIN TENSIONER ASSEMBLY
(a) Install the chain tensioner with the bolt.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
(b) While pushing in the tensioner, insert a pin of φ 1.0
mm (0.039 in.) into the hole to hold it.
37. INSTALL CAMSHAFT TIMING GEARS AND NO. 2
CHAIN (for Bank 2)
(a) Align the mark plate (yellow) with the timing marks
(2-dot mark) of the camshaft timing gears as shown
in the illustration.
(b) Apply a light coat of engine oil to the bolt threads
and bolt-seating surface.
(c) Align the knock pin of the camshaft with the pin hole
of the camshaft timing gear. Install the camshaft
timing gear and camshaft timing exhaust gear LH
with the No. 2 chain installed.
(d) Hold the hexagonal portion of the camshaft with a
wrench, and tighten the 2 bolts.
Torque: 100 N*m (1,020 kgf*cm, 74 ft.*lbf)
(e) Remove the pin from the chain tensioner.
38. INSTALL NO. 1 CHAIN VIBRATION DAMPER
(a) Install the chain vibration damper with the 2 bolts.
Torque: 23 N*m (230 kgf*cm, 17 ft.*lbf)
39. INSTALL NO. 2 CHAIN VIBRATION DAMPER
(a) Install the 2 chain vibration dampers.