Toyota 2GR-FE Manual page 858

CH–20
Deep socket
wrench (21 mm)
Pin
CH
2GR-FE CHARGING – GENERATOR
A118365E01
A128082E01
A128074
A079315E04
Pin
A079316E02
(c) Place a new generator washer on the generator
rotor.
3. INSTALL GENERATOR COIL ASSEMBLY
(a) Using a deep socket wrench (21 mm) and a press,
slowly press in the generator coil assembly.
(b) Install the 4 bolts.
Torque: 5.8 N*m (59 kgf*cm, 51 in.*lbf)
4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY
(a) While pushing the 2 brushes into the generator
brush holder assembly, insert a φ1.0 mm (0.039 in.)
pin into the brush holder hole.
(b) Install the brush holder assembly to the generator
coil with the 2 screws.
Torque: 1.8 N*m (18 kgf*cm, 16 in.*lbf)
(c) Pull out the pin from the generator brush holder.