Toyota 2GR-FE Manual page 132

CORRECT
SST
Taper Part
Plunger
Low Pressure
Chamber
Check Ball
High Pressure
Chamber
SST
Valve Rocker Arm
Lash
Adjuster
Valve Stem
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(b) Insert the SST's tip into the lash adjuster's plunger
INCORRECT
(c) Squeeze the SST and lash adjuster together to
(d) Check the movement of the plunger and bleed the
(e) After bleeding the air, remove the SST. Then, try to
High Pressure
Chamber
(f)
29. INSTALL NO. 1 VALVE ROCKER ARM SUB-
ASSEMBLY
(a) Apply engine oil to the lash adjuster tip and valve
A109630E01
(b) Make sure that the valve rocker arms are installed
30. INSTALL CAMSHAFT BEARING CAP (for Bank 1)
(a) Apply engine oil to the camshaft journals, camshaft
(b) Install the camshaft and No. 2 camshaft to the
Valve Stem Cap
A131901E01
(c) Make sure of the marks and numbers on the
A131902
and use the tip to press down on the check ball
inside the plunger.
SST 09276-75010
move the plunger up and down 5 to 6 times.
air.
OK:
Plunger moves up and down.
NOTICE:
When bleeding air from the high-pressure
chamber, make sure that the tip of the SST is
actually pressing the check ball as shown in the
illustration. If the check ball is not pressed, air
will not bleed.
press the plunger quickly and firmly with a finger.
OK:
Plunger is very difficult to move.
If the result is not as specified, replace the lash
adjuster.
Install the lash adjusters.
NOTICE:
Install the lash adjuster to the same place it was
removed from.
stem cap end.
as shown in the illustration.
housing and bearing caps.
camshaft housing RH.
camshaft bearing caps and place them in each
proper position and direction.
EM–131
EM