Remove Crankshaft Bearing/Crankshaft Thrust Washer Set/Piston Ring Set - Toyota 2GR-FE Manual

2 6
10
14
9 13
5
1
Protective Tape
Cylinder
Bearing Cap
Block
Joint Surface
Piston Ring
Expander
2GR-FE ENGINE MECHANICAL – ENGINE UNIT
(b) Uniformly loosen the 16 bearing cap bolts, in
8
4
16
12
15 11
7 3
A134892E01
(c) Using a screwdriver, pry out the main bearing caps.
(d) Remove the crankshaft.
66. REMOVE CRANKSHAFT BEARING
HINT:
Arrange the removed parts in the correct order.
A122567E01
67. REMOVE CRANKSHAFT THRUST WASHER SET
(a) Remove the upper bearings and upper thrust
A109726
68. REMOVE PISTON RING SET
(a) Using a piston ring expander, remove the 2
(b) Remove the oil ring expander and 2 side rails by
A129724E01
several steps and in the sequence shown in the
illustration.
Remove the 4 main bearing caps and lower
bearings.
NOTICE:
• Push up on the cap little by little, from the
right and left side alternately so that the cap
can be removed.
• Be careful not to damage the joint surface of
the cylinder block and the main bearing cap.
washers from the cylinder block.
compression rings.
hand.
HINT:
Arrange the removed parts in the correct order.
EM–85
EM