Lubrication System - Toyota 2GR-FE Manual

Recommended Viscosity (SAE)
5W-30
-29 -18 -7 4 16
°C
-20 0 20 40 60
°F
2GR-FE LUBRICATION – LUBRICATION SYSTEM

LUBRICATION SYSTEM

ON-VEHICLE INSPECTION
1. CHECK ENGINE OIL LEVEL
(a) Warm up the engine, stop it and wait 5 minutes. The
2. CHECK ENGINE OIL QUALITY
(a) Check the oil for deterioration, water contamination,
27 38
80 100
A066623E21
3. CHECK OIL PRESSURE
(a) Remove the engine under cover LH.
(b) Remove the engine under cover RH.
(c) Disconnect the oil pressure switch connector.
(d) Using a 24 mm deep socket wrench, remove the oil
A127994
(e) Install the oil pressure gauge with adapter.
(f)
(g) Measure the oil pressure.
A127995
oil level should be between the dipstick's low level
mark and full level mark.
If low, check for leakage and add oil up to the full
level mark.
NOTICE:
Do not fill above the full level mark.
discoloring or thinning.
If the quality is visibly poor, replace the oil.
Oil grade:
Use ILSAC multigrade engine oil. SAE 5W-30
engine oil may be used. However, SAE 5W-30
is the best choice for good fuel economy and
good starting in cold weather.
pressure switch.
Warm up the engine.
Standard oil pressure
Engine Condition
Idle
80 kPa (0.8 kgf*cm
6,000 rpm
If the oil pressure is not as specified, check the oil
pump (See page LU-13).
LU–1
Oil Pressure
2
, 11.6 psi) or more
2
380 kPa (3.9 kgf*cm , 55.5 psi) or
more
LU