Daewoo CIELO EURO III Manual page 95

DAEWOO T-154 BL2,3
SOHC ENGINE MECHANICAL 1B – 83
3. Clean the chippings from the cylinder head.
4. Inspect the dimension for the proper valve seat width.
Intake: 1.3 to 1.5 mm (0.051 to 0.059 inch)
Exhaust: 1.6 to 1.8 mm (0.063 to 0.071 inch)
5. Inspect the valve stem projection using the distance
gauge KM-419.
A102B058
6. If the dimension is exceeded, install new valves and
then check the valve stem projection again. Refer to
"Valve Grind" and "Valve Grind-In" in this section.
7. If the valve stem projection is still too large despite re-
placing the valves, replace the cylinder head.
A102B061
Assembly Procedure
1. Install the camshaft carrier alignment pins.
2. Install the valve stem oil seals.
3. Coat the valves with engine oil.
4. Install the valves.
5. Install the valve springs.
6. Using the valve spring compressor KM-348, com-
press the valve springs.
7. Install the valve keeper.
8. Install the valve spring cap.
A102B051