Dtc P1650 Spi Communications Between Error With Sidm Chip (1.5L Sohc) - Daewoo CIELO EURO III Manual

1F – 362 ENGINE CONTROLS
SPI COMMUNICATIONS BETWEEN ERROR WITH SIDM CHIP
System Description
Engine Control Module (ECM) detects if Serial Peripher-
al Interface (SPI) communication between main CPU
and output driver I/C is corrupted. The ECM monitors
specific bits in the SPI message structure. If bits are cor-
rupted, fail counter incremented.
Conditions For Setting The DTC
D Ignition ON.
D Ignition voltage is greater than 11 volts.
Action Taken When The DTC Sets
D The Malfunction Indicator Lamp (MIL) will not illumi-
nate.
D The ECM will store conditions which were present
when the DTC was set as Failure Records data only.
This information will not be stored in the Freeze
Frame data.
D A history DTC is stored.
DTC P1650 – SPI Communications Between Error with SIDM Chip (1.5L SOHC)
Step
Perform an On-Board Diagnostic (EOBD) System
Check.
1
Is the system check complete?
1. Install the scan tool and clear the Diagnostic
Trouble Code (DTC).
2. Review the Failure Record data with the ignition
ON and the engine OFF and note the
2
parameters.
3. Operate the vehicle with the Failure Record
conditions as noted.
Does DTC P1650 reset?
1. Turn the ignition OFF.
3 2. Replace the Engine Control Module (ECM).
Is the repair complete?
1. Using the scan tool, clear the Diagnostic Trouble
Codes (DTCs).
2. Start the engine and idle at normal operating
temperature.
4
3. Operate the vehicle within the conditions for
setting this DTC as specified in the supporting
text.
Does the scan tool indicate that this diagnostic ran
and passed?
Check if any additional DTCs are set.
5
Are any DTCs displayed that have not been
diagnosed?
DIAGNOSTIC TROUBLE CODE (DTC) P1650
(1.5L SOHC)
Action
Conditions For Clearing The DTC
D A history DTC will clear after 40 consecutive warm-up
cycles without a fault.
D The DTC(s) can be cleared by using the scan tool.
Test Description
The number(s) below refer to specific step(s) on the
diagnostic table.
1. On-Board Diagnostic (EOBD) System Check
prompts the technician to complete some basic
checks and store the freeze frame and failure re-
cords data on the scan tool if applicable. This
creates an electronic copy of the data taken when
the malfunction occurred. The information is then
stored on the scan tool for later reference.
3. The replacement ECM must be reprogrammed. Re-
fer to the least Techline procedure for ECM repro-
gramming.
Value
–
Go to Step 2
–
Go to Step 3
–
Go to Step 4
–
Go to Step 5
applicable DTC
–
Yes No
Go to "On-
Board Diag-
nostic System
Check"
–
–
Go to Step 2
Go to
table System OK
DAEWOO T-154 BL2,3