Daewoo CIELO EURO III Manual page 555

DAEWOO T-154 BL2,3
6. Remove the fuel inlet line.
7. Remove the fuel rail mounting bolts.
Notice: Before removal, the fuel rail assembly may be
cleaned with a spray-type cleaner, following package in-
structions. Do not immerse the fuel rails in liquid clean-
ing solvent. Use care in removing the fuel rail assembly
to prevent damage to the electrical connectors and the
injector spray tips. Prevent dirt and other contaminants
from entering open lines and passages. Fittings should
be capped and holes plugged during service.
Important: If a fuel injector becomes separated from
the fuel rail and remains in the cylinder head, replace the
fuel injector O-ring seals and the retaining clip.
8. Remove the fuel rail with the fuel injectors attached.
A102F006
9. Remove the fuel injector retainer clips.
10. Remove the fuel injectors by pulling them down and
out.
11. Discard the fuel injector O-rings.
A102F007
Installation Procedure
Important: Different fuel injectors are calibrated for dif-
ferent flow rates. When ordering new fuel injectors, be
certain to order the identical part number that is in-
scribed on the old fuel injector.
1. Lubricate the new fuel injector O-rings with engine oil.
Install the new O-rings on the fuel injectors.
2. Install the fuel injectors into the fuel rail sockets with
the fuel injector terminals facing outward.
3. Install the fuel injector retainer clips onto the fuel in-
jectors and the fuel rail ledge.
4. Make sure that the clip is parallel to the fuel injector
harness connector.
A102F008
ENGINE CONTROLS 1F – 385